Extensions to modeling aerobic carbon degradation using combined respirometric–titrimetric measurements in view of activated sludge model calibration

Recently a model was introduced to interpret the respirometric (OUR) –titrimetric (Hp) data obtained from aerobic oxidation of different carbon sources in view of calibration of Activated Sludge Model No.1 (ASM1). The model requires, among others, the carbon dioxide transfer rate (CTR) to be relatively constant during aerobic experiments. As CTR is an inherently nonlinear process, this assumption may not hold for certain experimental conditions. Hence, we extended the model to describe the nonlinear CTR behavior. A simple calibration procedure of the CO2 model was developed only using titrimetric data. The identifiable parameter subset of this model when using titrimetric data only contained the first equilibrium constant of the CO2 dissociation, pK1pK1, the initial aqueous CO2 concentration, CTinitCTinit and the nitrogen content of biomass, iNBMiNBM. The extended model was then successfully applied to interpret typical data obtained from respirometric–titrimetric measurements with a nonlinear CO2 stripping process. The parameter estimation results using titrimetric data were consistent with the results estimated using respirometric data (OUR) alone or combined OUR and Hp data, thereby supporting the validity of the dynamic CO2 model and its calibration approach. The increased range of applicability and accurate utilization of the titrimetric data are expected to contribute particularly to the improvement of calibration of ASM models using batch experiments.