Effects of indoor drinking water handling on trihalomethanes and haloacetic acids

In this study, different tap water handling strategies were investigated to evaluate the effects on two principal chlorinated DBPs, trihalomethanes (THMs) and haloacetic acids (HAAs). Tap water samples collected in the Quebec City (Canada) distribution system on a spatio-temporal basis were subjected to diverse indoor handling scenarios: storing water in the refrigerator, boiling water followed by storage and, finally, filtering water with a point-of-use commercial pitcher also followed by storage. In the first two cases, the use of covered and uncovered pitchers was investigated separately, while in the last case, both the use of new and used filters was compared. In all cases, maximum storage time was 48 h. Results demonstrated that in some cases, water handling scenarios have considerable effect, and in other cases, little or no effect. Removal of THM concentrations by simple storage was high (on average 30%) and very high by boiling and filtering with subsequent storage in the refrigerator (on average, 87% and 92%, respectively). In scenarios where water was stored in uncovered pitchers (with or without previous boiling and filtering), the THM decrease was higher for increased storage times. However, storage did not have any effect on HAAs, whereas boiling decreased levels of trichloroacetic acid (TCAA) (on average 42%) and increased levels of dichloroacetic acid (DCAA) (on average 35%), resulting in unchanged average levels of total HAAs. The use of the filtration pitcher decreased HAA levels dramatically (on average 66%). Percentages of change in chlorinated DBPs in the different scenarios varied according to initial concentrations in tap water (baseline water), that is, according to the spatio-temporal variations of these substances in the distribution system. On the basis of these results, the paper discusses implications regarding public health protection and exposure assessment for epidemiological studies.