Fractionation of flax shives with pressurized aqueous ethanol

Fractionation of flax shives into major biopolymer constituents, such as cellulose, hemicelluloses, and lignin, was carried out with pressurized aqueous ethanol in a pressurized low-polarity water extractor. The effect of processing parameters such as temperature, ethanol concentration, flow rate, sample size and solvent/feed ratio on the simultaneous extraction of hemicelluloses and lignin was determined. More than 80% of total hemicelluloses and ∼78% of total lignin were removed simultaneously in a single step under the following conditions: 180 °C, 30% (v/v) ethanol concentration, 3 mL/min flow rate, and 45 mL/g solvent/feed ratio. Under these extraction conditions, cellulose degradation was negligible. Further, the separation of lignin from hemicelluloses was carried out using two simple alternative methodologies based on precipitation. Since no acidic or alkali catalysts were used, the degradation of biopolymers was negligible and the oligomer/monomer ratio of sugars was 825:1. Characterization of fractionated biopolymers was carried out with scanning electron microscopy and a Fourier-transform infrared spectrometer (FT-IR). FT-IR spectra of isolated lignin and hemicelluloses showed that both polymers were comparable to commercially available products.

• Fractionation of flax shives was carried out with pressurized aqueous ethanol (PAE).
• 30% PAE without additives resulted in negligible cellulose degradation.
• Extraction of hemicelluloses (80%) and lignin (78%) was quantitative and simultaneous.
• Both isolated lignin and hemicelluloses were of high purity.
• FT-IR spectra of isolated lignin showed that it was similar to organosolv lignin.