Heat transfer and crisis phenomena at pool boiling of liquid nitrogen on the surfaces with capillary-porous coatings

The results of experimental study of heat transfer and crisis phenomena at pool boiling of liquid nitrogen with different heating conditions on the surface with capillary-porous coating are presented. Porous coatings with different thicknesses (400 and 1390 μm), morphology and high porosity (up to 80%) were obtained using the new plasma spraying technique. It was shown that at steady-state heat release the heat transfer at boiling essentially depends on the thickness and morphology of the coating. The maximum enhancement (∼300%) compared to the smooth heater was detected to coated heater with a thickness of 1390 μm at low heat fluxes. The mechanism of heat transfer enhancement at pool boiling by using the capillary-porous coatings was proposed. Heat transfer hysteresis was detected for the heater with the coating of 400 μm. For the smooth heaters and the heater with 1390 μm coating, the heat transfer coefficients almost coincide with an increase in the heat flux and with its decrease. Data on the effect of coatings with different thicknesses on the critical heat flux (CHF) at boiling under steady-state heat release are presented. It is shown that for the smooth heaters the value of critical heat flux at rapid heating decreases in comparison with steady-state heat release. Capillary-porous coatings have a significant influence on development of the transition process and crisis phenomena at stepwise heat release. There is degeneration of boiling crisis development at rapid heating on the coated surfaces at the heat fluxes below the value of the CHF at steady state heat release. Fast transition to film boiling at stepwise heat release on the coated heaters with different thicknesses is observed at the heat fluxes 2 times higher than the critical heat fluxes, obtained at steady state heating.