Fabrication of nickel stamp with improved sidewall roughness for optical devices

We proposed the simple and attractive fabrication method of nickel stamp with improved sidewall roughness for polymeric optical devices. For this, the imprinted optical devices patterns under optimum imprinting conditions were annealed to improve the sidewall roughness generated by the DRIE process in the silicon stamp fabrication. The annealed sidewall roughness is reduced to 24.6 nm, nearly decreasing by 76% compared with the result before the annealing. Then, low cost and durable nickel stamp with improved sidewall roughness was fabricated by the annealed polymeric patterns being used as original master for electroforming process. And, we verified the superiority of the improved nickel stamp by comparing the optical propagation losses for optical waveguides to be fabricated, respectively, using the nickel stamp and original silicon stamp. The optical waveguides fabricated by the imprint lithography using the improved nickel stamp was demonstrated that their optical losses were reduced as 0.21 dB/cm, which was less than the propagation loss for polymeric waveguides using the conventional original silicon stamp. This result could show the effectiveness of the fabricated nickel stamp with improved sidewall roughness. Furthermore, we were able to successfully fabricate a polymeric 1 × 8 beam splitter device using the improved nickel stamp. And, the insertion loss for eight channels obtained to be from 10.02 dB to 10.91 dB.

Figure optionsDownload as PowerPoint slideHighlights
► We proposed the attractive method of fabricating a low cost and durable nickel stamp with improved sidewall roughness.
► The sidewall roughness was improved by below 25nm, nearly decreasing by 76% compared with the results before the annealing.
► Using the improved nickel stamp, we fabricated a high efficiency polymeric optical waveguide and PLC device.
► The measured propagation loss for optical waveguide to be fabricated by using nickel stamp is 0.16 dB/cm.