کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
543673 | 1450396 | 2008 | 5 صفحه PDF | دانلود رایگان |
The feature size for next-generation devices is decreasing and edge exclusion widths are becoming stricter, decreasing from 2 to 1.5 mm. The development of a new porous pin chuck is thus necessary for flattening large wafers, including the periphery, which has small and extremely low pins. A reverse production process from the conventional method was adopted to form pins after careful polishing of the chuck surface. It is now possible to both measure and achieve a high level of flatness for pin chucks, while reducing vacuum leakage. Average pin heights were 33 μm in the suction region and 5 μm in the static-pressure seal. The uniformity of pin heights in the seal was improved compared with the conventional static-pressure-seal pin chuck. In addition, the contact ratio between the back surface of a wafer and the pin tops was reduced to 25% that of conventional static-pressure-seal pin chucks by using pins with smaller diameters and porous material.
Journal: Microelectronic Engineering - Volume 85, Issues 5–6, May–June 2008, Pages 749–753