Effect of headgroups on the aggregation behavior of cationic silicone surfactants in aqueous solution

Three cationic silicone surfactants, 1-methyl-3-[tri-(trimethylsiloxy)]silylpropyl-imidazolium chloride (Si4mimCl), (2-hydroxyethyl)-N,N-dimethyl-3-[tri-(trimethylsiloxy)]silylpropylammonium chloride (Si4mam-OHCl), 1-methyl-1-[tri-(trimethylsiloxy)]silylpropylpyrrolidinium chloride (Si4pyCl), with the same hydrophobic group and different headgroups were synthesized. Their aggregation behavior in aqueous solution was systematically investigated by surface tension, electrical conductivity, and steady-state fluorescence. Surface tension of water can be reduced almost to 20 mN m−1 with the addition of the cationic silicone surfactants. This result indicates that all the three surfactants exhibit remarkable surface activity. Because of the effect of the headgroups, the critical micelle concentrations (CMC) values increase following the order Si4pyCl < Si4mimCl < Si4mam-OHCl, and Si4pyCl packs more tightly at the air/water interface compared with Si4mimCl and Si4mam-OHCl. Electrical conductivity measurements show that all the three cationic silicone surfactants have low degree of counterion binding (β) and the β values for Si4pyCl and Si4mam-OHCl increase with increasing the temperature in the investigated temperature range. Thermodynamic parameters (ΔHm0, ΔSm0, and ΔGm0) of micellization indicate that the micellization for Si4mimCl in aqueous is enthalpy-driven, and that for both the Si4pyCl and Si4mam-OHCl entropy-driven.

Aggregation behaviors of three novel cationic silicone surfactants are investigated. The figure of β–T for Si4mimCl, Si4pyCl and Si4mam-OHCl shows that the values of β for Si4pyCl and Si4mam-OHCl increase as the temperature increases.Figure optionsDownload as PowerPoint slideHighlights
► Cationic silicone surfactants with the same hydrophobic group and different headgroups were synthesized.
► Cationic silicone surfactants have higher surface activity compared with common hydrocarbon surfactants.
► The β values for Si4pyCl and Si4mam-OHCl increase with increasing the temperature in the investigated temperature range.