Identifying non-point source critical source areas based on multi-factors at a basin scale with SWAT

- CSAs were identified based on multi-factors with Soil and Water Assessment Tool.
- Not only nutrient loads but also population density and water quality requirements determine CSAs locations.
- SWAT calibration and validation had little effect on CSAs identification.

SummaryThe identification of critical source areas (CSAs) is a precondition for non-point source (NPS) pollution control at a basin scale, especially in areas with limited resources. Based on the Soil and Water Assessment Tool (SWAT), nutrient loads coupled with population density and water quality requirements are regarded as multi-factors for CSAs identification in Xiangxi river watershed, the first tributary of the Yangtze River. The results based on the calibrated model found that the subbasins heavily and seriously polluted by nutrient loads were different from the subbasins identified as CSAs, demonstrating integrating socio-economic factors like population density and water quality requirements to identify CSAs is of much necessity. The CSAs occupied 19.7% of the total subbasins, and accounted for 53% total nitrogen loads, 54% total phosphorus loads and 36% of the total population. Considering the model calibration and validation will take a long time as well as data deficiency in some subbasins, the influence of uncalibrated SWAT on CSAs identifications was discussed. The comparative results between CSAs identification with calibrated and uncalibrated SWAT model revealed that model calibration had little effect on nutrients distribution and CSAs locations in the study area. Uncalibrated SWAT model may be applied when the research objective is less related to model calibration. The results will be greatly effective for CSAs identification and NPS pollution control at a basin scale.