Selective hydrogenation of o-chloronitrobenzene (o-CNB) over supported Pt and Pd catalysts obtained by laser vaporization deposition of bulk metals

Carbon nanotubes (CNTs), γ-alumina (γ-Al2O3) and silica (SiO2) supported Pt and Pd catalysts were produced by laser vaporization deposition of respective bulk metals. The catalysts were characterized by inductive coupled plasma emission spectrometer (ICP), X-ray photoelectron spectroscopy (XPS) and transmission electron microscopy (TEM). The catalytic properties of the catalysts were investigated in the liquid phase hydrogenation of o-chloronitrobenzene (o-CNB) to o-chloroaniline (o-CAN) under 333 K and 1.0 MPa hydrogen pressure. The results show that the catalytic properties are greatly affected by the supports. Pt/CNTs catalyst exhibits the best catalytic performance among the Pt-based catalysts, producing o-CAN with 99.6% selectivity at complete conversion. Pd/CNTs catalyst exhibits the best catalytic performance among the Pd-based catalysts, giving o-CAN with 95.2% selectivity at complete conversion. For Pt-based catalysts, geometric effect and the textures and properties of the supports play important roles on catalytic properties. On the other hand, geometric effect, electronic effect and the textures and properties of the supports simultaneously influence the catalytic properties of the Pd-based catalysts. In addition, hydrogenolysis of the C–Cl bond can be well inhibited over all catalysts prepared by laser vaporization deposition.

The catalysts were prepared in the system of laser vaporization deposition. (1) Laser; (2) chamber; (3) N2 cylinder; (4) vacuum pump; (5) stirrer; (6) vacuum meter; (7) metallic rod; (8) plasma; (9) support; (10) quartz dish; (11) strip heater; (12) magnetic stirrer.Figure optionsDownload as PowerPoint slide