کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
7044590 1457086 2018 38 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Multi-attribute optimization of a novel micro liquid block working with green graphene nanofluid regarding preferences of decision maker
ترجمه فارسی عنوان
بهینه سازی چندین ویژگی یک بلوک مایع مایکروویو جدید با نانوفیلد گرافن سبز در مورد تنظیم کننده تصمیم گیرنده
کلمات کلیدی
گرافن نانوفیلد، کارکرد سبز، بلوک میکرو مایع، خنک کننده الکترونیک، بهینه سازی، تصمیم سازی،
ترجمه چکیده
این تحقیق به بررسی ویژگی های هیدروترمال نانوسیم گرافن سبز در دو بلوک میکرو مایع جدید می پردازد. نانولوله های گرافن که توسط یک روش بیولوژیکی کاربرد دارند، استفاده می شود. نتایج نشان می دهد که با افزایش سرعت جریان یا گرانش گرافن، خنک سازی افزوده می شود و دمای سطح گرما کاهش می یابد. علاوه بر این، یکنواختی توزیع دما با افزایش غلظت و سرعت بهبود می یابد. یافته شده است که احتمال تشکیل نقطه داغ در پردازنده الکترونیکی در مورد استفاده از نانوسیم به جای مایع پایه کمتر است. علاوه بر این، افزایش پمپاژ مورد نیاز با افزایش تلفات و سرعت افزایش می یابد. شکل شایستگی در غلظت های بالاتر بیشتر است، که شایستگی برتر استفاده از نانوسیم را نشان می دهد. دو بلوک مایع مختلف با یکدیگر مقایسه می شوند و بهتر است برای رسیدن به حداقل دمای سطح همراه با حداقل پمپاژ، بهینه شود. بهینه سازی برای نمرات اولویت های مختلف تابع هدف بر اساس ترجیحات تصمیم گیرنده انجام می شود و شرایط مطلوب گزارش شده و مورد بحث قرار می گیرد. استفاده از نانوسیم با حداکثر غلظت توصیه می شود برای تمام شرایط، به جز مواردی که اولویت های پمپاژ قدرت و درجه حرارت سطح بسیار بالا و بسیار پایین است.
موضوعات مرتبط
مهندسی و علوم پایه مهندسی شیمی جریان سیال و فرایندهای انتقال
چکیده انگلیسی
This research attempts to examine hydrothermal attributes of the green graphene nanofluid in two novel micro liquid blocks. The graphene nanoplatelets functionalized by a biological method are employed. The results reveal that by increasing either flow velocity or graphene concentration, the cooling is augmented and the temperature of heating surface reduces. Moreover, the uniformity of temperature distribution improves with increase of the concentration and velocity. It is found that the possibility of hot spot formation on the electronic processor is lower in the case of using nanofluid rather than the base fluid. In addition, the required pumping power intensifies by increasing the concatenation and velocity. Figure of merit is greater at higher concentrations, which shows the superior merit of using the nanofluid. Two different liquid blocks are compared and the better one is optimized to reach minimum surface temperature along with minimum pumping power. The optimization is carried out for different priority grades of objective functions based on preferences of decision maker, and the optimal conditions are reported and discussed. Employing the nanofluid with maximum concentration is recommended for all conditions except the cases in which priorities of pumping power and surface temperature are very high and very low, respectively.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Applied Thermal Engineering - Volume 143, October 2018, Pages 11-21
نویسندگان
, , ,