کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
78865 | 49343 | 2011 | 7 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Thin film solar cells of CdS/PbS chemically deposited by an ammonia-free process Thin film solar cells of CdS/PbS chemically deposited by an ammonia-free process](/preview/png/78865.png)
A new type of solar cell with structure glass/ITO/CdS/PbS/conductive graphite was constructed and studied. Both window (CdS) and absorption (PbS) layers were deposited by means of the chemical bath deposition (CBD) technique. The maximum temperature employed during the solar cell processing was 70 °C and it did not include any post-treatment. In case of the CdS window layer, complexing agents alternative to ammonia were employed in the CBD process and their effects on the CdS films properties were studied. The solar cells are photosensitive in a large spectral range (all visible and near infrared regions); the cell with the area of 0.16 cm2 without any special treatment has shown the values of open-circuit voltage Voc of 290 mV and short circuit current Jsc of 14 mA/cm2 with the efficiency η=1.63% (fill factor FF is 0.36) under illumination intensity of 900 W/m2. It was found that the CBD-made PbS layer has a certain degree of porosity, which favorably affects its applicability in solar cell construction. The possible ways of device optimization, and in particular, the effect of the PbS grain size on its performance are discussed.
Research highlights
► Solar cell with structure Glass/ITO/CdS/PbS/conductive graphite is developed.
► The ammonia free chemical bath deposition was employed at all main stages.
► The technique is of low cost and low energy consumption.
► The efficiency obtained without any treatment was 1.63%.
► The absorbing PbS layer is porous, which is favorable for solar cell application.
Journal: Solar Energy Materials and Solar Cells - Volume 95, Issue 7, July 2011, Pages 1882–1888