Identification of stiffness variations in supporting substances of a human canine tooth with a bracket-beam-piezoelectric sensor and its electromechanical impedance

In this paper, an experimental method is described to identify the stiffness variations produced by drillings done in different supporting substances of a human canine tooth. To measure the supporting substances parameters through of a canine, a sensor-actuator system was developed. The sensor-actuator device was composed of a stainless steel bracket bonded to a steel wire attached to two piezoelectric transducers, with a concentrated mass attached to the end of the wire. To excite the device, high frequency voltage (between 5 and 10 KHz) was applied through the piezo-transducers, which affects the tooth by means of the vibration of the wire. High frequency mechanical vibrations allowed the appraisal of the mechanical response from the supporting substances. Mechanical responses associated with the stiffness of the support were quantified with the electrical impedance of the piezo-transducers. The device was coupled to the crown of a canine tooth simulating a condition of fixing as in the bone, the tooth was fastened by the root portion inside the supporting substance. Four supporting substances were characterized for the tests. After establishing base values of the stiffness of each supporting substance, the stiffness variations were assessed in two stages (two drillings); these were made perpendicularly to the longitudinal axis of the tooth, Results show that it is possible to assess stiffness variations with the proposed methodology as well as to quantify the stiffness differences, by means of variation indexes.