Polymerization efficiency and flexural strength of low-stress restorative composites

ObjectivesTo assess depth of cure (DOC), degree of conversion (DC), and flexural strength (FS) of several resin composites with low-stress behavior.MethodsSonicFill (Kerr), SureFil® SDR™ (Dentsply), everX Posterior (GC), Kalore (GC), and Filtek Silorane (3M ESPE) were tested. DOC was measured with the Acetone Shake test. DC was assessed with Fourier Transform Infra-Red spectroscopy on top and at the bottom of 4 mm-thick disk-shaped specimens. Bottom to top ratios of DC percentages were calculated. FS was evaluated with the Three-Point Bending test. DOC, DC, and FS data were statistically analyzed.ResultsSureFil® SDR™ and everX Posterior achieved significantly greater DOC than Kalore and Filtek Silorane. Also, SonicFill had significantly greater DOC than Filtek Silorane. Mean top DCs ranged between 71.46% and 52.44%. Kalore and everX Posterior had significantly lower top DCs than the other materials. Mean DC values at 4 mm ranged largely from 57.95% to 6.82%. Kalore and Filtek Silorane had the lowest values of bottom DC and the difference was statistically significant. EverX Posterior and SonicFill recorded significantly higher FSs than the other materials.SignificanceSureFil® SDR™ and everX Posterior exhibited DOC over 4 mm, the maximum thickness recommended for bulk placement, while SonicFill recorded DOC values very close to the 4 mm threshold. SonicFill achieved the highest DC at the irradiated surface, as well as at 4 mm depth. SureFil® SDR™ demonstrated similarly uniform curing through the bulk increment. All the tested composites complied with the requirements of FS established by ISO 4049/2009.