Fabrication of microelectrodes using flow layer-by-layer self assembly of gold nanoparticles

Microelectrodes to be used in microfluidic devices were prepared from the layer-by-layer flow deposition of gold nanoparticles. Pre-designed microfluidic channels were used as templates for the flow driven deposition of the nanoparticles in sequence with poly (diallyldimethyl amonium chloride) (PDADMAC). The electrical resistivity of the gold nanoparticle assembly was found to be strongly dependant on the concentration of sodium citrate used in the gold nanoparticle synthesis. As the electrical properties of the film changed from insulating to conducting when decreasing the citrate concentration, a 4 point probe setup was used to measure the resistivity of the film. Near bulk conductivity (5.42 × 10−6 Ω cm) was achieved with only 10 layers of film. The thickness and morphology of the flow-printed multilayer microelectrode was characterized using atomic force microscopy (AFM) and a field emission scanning electron microscope (FE-SEM). To demonstrate its usefulness, the microelectrode assembly was then tested toward the detection of KCl in solution, having a concentration ranging from 1 to 20 mM using AC current detection in a simple setup. Good linearity and stability of the electrode confirmed that this method could be very convenient for the fabrication of microelectrodes for lab-on-chip applications.

► Simple and inexpensive method for the fabrication of micro-patterned electrodes.
► Fabrication of microelectrodes for conductivity detection in microfluidic devices.
► Low electrical resistivity of resulting layer-by-layer assembly thin film as bulk gold.
► Microelectrodes fabrication at ambient condition.