The role of surface kinetics on composition and quality of AlGaN

• A kinetic framework for controlling the surface during AlGaN growth on Al-polar surfaces by MOCVD is developed.
• The role of surface morphology and surface kinetics on AlGaN composition is presented.
• Apparent phase separation of AlGaN was determined not to be an intrinsic property of AlGaN.

Metal–polar, Al-rich AlGaN films were grown on both single crystalline AlN and sapphire substrates. The role of surface morphology and surface kinetics on AlGaN composition is presented. With the reduced dislocation density of the films grown on AlN substrates, atomically smooth bilayer stepped surfaces are achieved with RMS roughness of less than 50 pm for a 5×5 µm2 AFM scan area. By controlling the surface supersaturation through adjusting the growth rate, a transition from 2D nucleation to step flow was observed. The critical misorientation angle for step-bunching in nominal Al0.70Ga0.30N grown with a growth rate of 600 nm/h on AlN substrates was found to be 0.4°. The composition of bilayer stepped AlGaN was strongly dependent on substrate misorientation angle, where a compositional variation by a factor of two for a change in misorientation angle from 0.05 to 0.40° was observed; this is explained by the different surface diffusion lengths of Ga and Al. Step-bunching resulted in strong compositional inhomogeneity as observed by photoluminescence and scanning transmission electron microscopy studies.