Tectonic classification of Cenozoic Iberian foreland basins

The Iberian microcontinent stands out because of its intense Alpine intraplate deformation. This is reflected in a large number of Cenozoic basins of very different sizes. Most of the contacts between topographic highs and basins are thrust or strike-slip faults. All these basins seem to have undergone a common sedimentary evolution, comprising four stages: initiation of sedimentation, intense syn-tectonic infilling, change from endorheic to exorheic drainage, and accelerated erosion related to fluvial incision. This simple evolutionary model shows a migration from East to West, in which basins are still tectonically active at the Atlantic margin of Iberia. This common evolution is also found in a series of geometrical characteristics, such as the ratio r of length of strike-slip fault and length of thrust fault, that are very similar in both types of basin border settings. Thrust-related basins are mainly associated with segmented pop-downs, whereas the main basins have the characteristics of open-ramp basins. Strike-slip related basins are mostly transpressive structures, although small pull-apart basins are usual along the Vilariça and Messejana faults. For basin areas larger than 100–1000 km2, a constant r value of 0.6 is found (including the Ebro, Duero, Madrid, Lower Tagus and Badajoz basins). Within the Iberian microcontinent, the total amount of Cenozoic contractional deformation was distributed between strike-slip and thrust faults with an r ratio close to 0.6. However, for small basins this parameter seems to depend on the type of fault, range or deformation belt (pure strike-slip, transtension, transpression, and pop-up) independently of its local tectonic development.

Research Highlights
► In this study we analyze the Cenozoic tectonic evolution of more than 64 Iberian foreland basins.
► Most of the contacts between topographic highs and basins are thrust or strike-slip faults.
► All these basins seem to have undergone a common sedimentary evolution, comprising four stages: initiation of sedimentation, intense syn-tectonic infilling, change from endorheic to exorheic drainage, and accelerated erosion related to fluvial incision.
► For basin areas larger than 100–1000 km2, a constant r value of 0.6 is found.
► For small basins this parameter seems to depend on the type of fault, range or deformation belt (pure strike-slip, transtension, transpression, and pop-up) independently of its local tectonic development.