Non-double-couple mechanisms of microearthquakes induced during the 2000 injection experiment at the KTB site, Germany: A result of tensile faulting or anisotropy of a rock?

Moment tensors of microearthquakes induced during the 2000 injection experiment at the KTB deep drilling borehole at a depth level of 5.4 km are studied. A family of 37 most reliable moment tensors contains significant non-double-couple (non-DC) components. The DC is on average 60% and the non-DC is 40%. Fault plane solutions computed from the DC part show preferred strike-slip mechanisms with small normal or reverse components. A predominant azimuth of P and T axes is in the range of N320°–340°E and of N230°–250°E, respectively. The non-DC components contain both the isotropic (ISO) and compensated linear vector dipole (CLVD) components. The mean value of ISO is 1.5%, the mean value of CLVD is − 5.7%. The predominantly negative CLVD components are inconsistent with the concept of the non-DC mechanisms as a result of tensile faulting due to fluid injection into the rock. The main origin of the non-DC components is probably anisotropy in the focal area. The other origins are errors produced by mismodelling of the medium when calculating the Green functions, and numerical errors produced by noise and limitations of input data. Adopting four alternative models of anisotropy obtained by other seismic measurements at the KTB, we have employed the non-DC components for estimating an optimum orientation of anisotropy in the focal area. The optimum orientation of the symmetry plane of anisotropy is nearly vertical with a strike of N335°–340°E. This strike coincides well with the strike of 330° typical for many major lithological units and faults and with the orientation of the transversely isotropic model inferred by other authors. After removing the anisotropy effects from the moment tensors by calculating the source tensors, the distribution of ISO is significantly narrowed. This indicates predominantly shear, but not tensile faulting.