Fracture analysis in the south-western Corinth rift (Greece) and implications on fault hydraulic behavior

This paper reviews the data concerning the fracture network and the hydraulic characteristics of faults in an active zone of the Gulf of Corinth. Pressure gap measured through fault planes shows that in this area the active normal faults (Aigion, Helike) act, at least temporarily and locally, as transversal seal. The analysis of the carbonate cements in the fractures on both the hangingwall and the footwall of the faults also suggests that they have acted as local seals during the whole fault zone evolution. However, the pressure and the characteristics of the water samples measured in the wells indicate that meteoric water circulates from the highest part of the relief to the coast, which means it goes through the fault zones. Field quantitative analysis and core studies from the AIG-10 well have been performed to define both regional and fault-related fracture networks. Then laboratory thin section observations have been done to recognize the different fault rocks characterizing the fault zone components. These two kinds of approach give information on the permeability characteristics of the fault zone. To synthesize the data, a schematic conceptual 3D fluid flow modeling has been performed taking into account fault zone permeability architecture, sedimentation, fluid flow, fault vertical offset and meteoric water influx, as well as compaction water flow. This modeling allows us to fit all the data with a model where the fault segments act as a seal whereas the relays between these segments allow for the regional flow from the Peloponnese topographic highs to the coast.