Single- and two-phase fluid flow properties of cataclastic fault rocks in porous sandstone

Understanding the impact of faults on fluid flow in the subsurface is important for the extraction of oil, gas and groundwater as well as the geological storage of waste products. We address two problems present in current industry-standard workflows for fault seal analysis that may lead to fault rocks not being represented adequately in computational fluid flow models. Firstly, fluid flow properties of fault rocks are often measured only for small-scale faults with throws not exceeding a few centimetres. Large seismic-scale faults (throws >20 m) are likely to act as baffles or conduits to flow but they are seldom recovered from subsurface cores and consequently fault rock data for them is sparse. Secondly, experimental two-phase fluid flow data is lacking for fault rocks and, consequently, uncertainties exist when modelling flow across faults in the presence of two or more immiscible phases. We present a data set encompassing both single- and two-phase fluid flow properties of fault and host rocks from the 90-Fathom fault and its damage zone at Cullercoats Bay, NE England. Measurements were made on low-throw single and zones of deformation bands as well as on slip-surface cataclasites present along the ∼120 m throw main fault. Samples were analysed using SEM and X-ray tomography prior to petrophysical measurements. We show that single deformation bands, deformation band zones and slip-surface cataclasites exhibit dissimilar single- and two-phase fluid flow properties. This is due to grain-size reduction being more pronounced in slip-surface cataclasites and changes in microstructure being fault-parallel for deformation bands but mostly fault-perpendicular for slip-surface cataclasites. A trend of fault rocks with low absolute permeabilities exhibiting lower relative permeabilities than more permeable rocks at the same capillary pressure is evident.

► Single- and two-phase fluid flow data for fault rocks from the 90-Fathom fault, UK.
► First study to compare two-phase flow properties of large- and small-scale faults.
► Different cataclastic fault rock types exhibit dissimilar fluid flow properties.
► Fault-parallel versus perpendicular microstructural variations facilitate disparities.
► Relative permeability decreases with decreasing absolute permeability.