Terra infirma: Understanding salt tectonics

Following common usage, we broaden the term “salt” to include all rock bodies composed primarily of halite (NaCl). Salt is mechanically weak and flows like a fluid, even at geologically rapid strain rates. Salt is also relatively incompressible so is less dense than most carbonates and all moderately to fully compacted siliciclastic rocks. Salt's fluid rheology and incompressibility make it inherently unstable under a wide range of geologic conditions.The primary driving force for salt tectonics is differential loading, which may be induced by gravitational forces, by forced displacement of one boundary of a salt body relative to another, or by a thermal gradient. Buoyancy, long considered a key driver for salt tectonics, is of secondary importance in many settings. Two factors resist salt flow: strength of the overburden and boundary drag along the edges of the salt body. Salt will move only if driving forces exceed the resistance to flow.In order for a salt diapir to be emplaced into its overburden, any rock previously occupying that space must be removed or displaced. Emplacement may occur by extension, erosion, or uplift of the overburden or by overthrusting of the salt. Once salt reaches the surface, it can continue to rise by passive diapirism, in which the diapir grows as sediments accumulate around it. A rapidly rising passive diapir may spread over the sediment surface to form an allochthonous salt sheet. A variety of salt-sheet lineages are possible, depending on the geometry of the feeder and the tectonic setting.Because salt is weak, its tectonism is closely tied to regional deformation. In extension or transtension, diapirs rise up graben axes, taking advantage of the space created by thinning and separation of fault blocks. Later, once the salt source layer is exhausted, diapirs may fall as they continue to widen. In addition, salt typically acts as a detachment in both gravity-driven and basement-involved extension. In compression or transpression, preexisting diapirs are rejuvenated as salt is displaced upward by lateral shortening. This rise is enhanced by buckling and disruption of the diapir roof. In the absence of precursor structures, salt's primary role in compression is to act as a detachment. Some salt sheets may be emplaced in the hanging walls of thrust faults.