Mechanical and mineral properties of osteogenesis imperfecta human bones at the tissue level

- We compare biomechanical and mineral properties of OI and healthy cortical bones.
- We used Raman microspectroscopy to assess the chemistry in OI children's bones.
- We measured a significantly higher tissue mineral density in OI bones using tomography.
- We measured a significantly lower Young's modulus in OI bones using nanoindentation.
- We report a decrease in the mechanical properties of OI associated with smaller crystals.

Osteogenesis imperfecta (OI) is a genetic disorder characterized by an increase in bone fragility on the macroscopic scale, but few data are available to describe the mechanisms involved on the tissue scale and the possible correlations between these scales. To better understand the effects of OI on the properties of human bone, we studied the mechanical and chemical properties of eight bone samples from children suffering from OI and compared them to the properties of three controls. High-resolution computed tomography, nanoindentation and Raman microspectroscopy were used to assess those properties. A higher tissue mineral density was found for OI bone (1.131 gHA/cm3 vs. 1.032 gHA/cm3, p = 0.032), along with a lower Young's modulus (17.6 GPa vs. 20.5 GPa, p = 0.024). Obviously, the mutation-induced collagen defects alter the collagen matrix, thereby affecting the mineralization. Raman spectroscopy showed that the mineral-to-matrix ratio was higher in the OI samples, while the crystallinity was lower, suggesting that the mineral crystals were smaller but more abundant in the case of OI. This change in crystal size, distribution and composition contributes to the observed decrease in mechanical strength.