Structure and physical properties of pectins with block-wise distribution of carboxylic acid groups

The physical and the interfacial properties of pectins de-esterified by a specific block-wise enzymatic procedure were investigated. Two major types of block-wise de-esterified pectins with different internal distribution of carboxylic acid on the pectin chains were explored. Type C and type U pectins with the same degree of methylesterification are different and a more block-wise intramolecular distribution in comparison to commercial native apple pectin. The most ordered pectin (U63 pectin, 63% methylesterified pectin) has the highest electrophoretic mobility (ζ-potential). It reveals more pronounced intermolecular interactions since it exhibited, at low pH, the lowest circular dichroism intensity at shorter wavelength. U63 pectin (at acidic pH, without calcium addition) has a higher viscosity and formed a stronger gel compared to the less ordered C63 pectin and/or native apple pectin. X-ray patterns show that powdered U63 pectin is more crystalline than C63 pectin, while apple pectin is mostly amorphous. The modified pectin also, most effectively, reduced the surface tension (55 mN/m) and the interfacial tension (5.6 mN/m), probably due to the preferred surface orientation of the carboxylic groups at the water/air or water/oil interfaces.It was demonstrated that the internal charge distribution within the backbone of the pectin is an effective factor in its crystalline organization and its solution properties.It is, therefore, expected that the U63 pectin will exhibit better emulsification capabilities and will form stronger complexes with proteins.