Microstructures and their implications for faulting processes -Insights from DGLab core samples from the Gulf of Corinth

We have examined microstructures, mineralogical composition, geochemical alteration, and texture of four selected fault rock samples from the Deep Geodynamical Laboratory (DGLab) Gulf of Corinth project using optical microscopy, cathodoluminescence microscopy (CL), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and synchrotron X-ray diffraction measurements. The fault core is composed of red and gray clayey gouge material and surrounded by a damage zone of brecciated limestones. Pressure solution features, calcite veins and calcite clasts in the breccia and gouge material attest the presence of paleo-fluids and fluid-driven mass transfer during deformation. Differences in CL-colors between the matrix and calcite vein cement and inside the vein cement suggest repeated infiltration of fluids with different composition from various sources (formation water and meteoric water). Twin lamellae densities estimated in calcite veins are used as paleo-piezometer. The deduced differential stress is ∼140 ± 70 MPa for the older vein generation and appears to be higher than stress for the youngest veins (45 ± 23 MPa). In spite of the relatively small clay content in both samples, newly formed clay minerals have been observed in gray as well as red clayey gouge material. Differences between gray and red clay gouge material are found in fault rock composition, porosity and clay fabric. The proportion of chlorite in the red gouge is significantly less than that in the gray gouge whereas the initial porosity is significantly higher than in the gray gouge material. The detection of a well-oriented clay fabric in red clay gouge samples is unique in comparison to other major fault zones.