کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
81849 | 158354 | 2013 | 13 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Comparison of static chambers to measure CH4 emissions from soils Comparison of static chambers to measure CH4 emissions from soils](/preview/png/81849.png)
The static chamber method (non-flow-through-non-steady-state chambers) is the most common method to measure fluxes of methane (CH4) from soils. Laboratory comparisons to quantify errors resulting from chamber design, operation and flux calculation methods are rare. We tested fifteen chambers against four flux levels (FL) ranging from 200 to 2300 μg CH4 m−2 h−1. The measurements were conducted on a calibration tank using three quartz sand types with soil porosities of 53% (dry fine sand, S1), 47% (dry coarse sand, S2), and 33% (wetted fine sand, S3). The chambers tested ranged from 0.06 to 1.8 m in height, and 0.02 to 0.195 m3 in volume, 7 of them were equipped with a fan, and 1 with a vent-tube. We applied linear and exponential flux calculation methods to the chamber data and compared these chamber fluxes to the reference fluxes from the calibration tank.The chambers underestimated the reference fluxes by on average 33% by the linear flux calculation method (Rlin), whereas the chamber fluxes calculated by the exponential flux calculation method (Rexp) did not significantly differ from the reference fluxes (p < 0.05). The flux under- or overestimations were chamber specific and independent of flux level. Increasing chamber height, area and volume significantly reduced the flux underestimation (p < 0.05). Also, the use of non-linear flux calculation method significantly improved the flux estimation; however, simultaneously the uncertainty in the fluxes was increased. We provide correction factors, which can be used to correct the under- or overestimation of the fluxes by the chambers in the experiment.
► Static chamber method is the most common method to measure methane emissions from soils.
► We quantified errors resulting from chamber size and flux calculation method.
► Chambers underestimated the methane fluxes with linear flux calculation method.
► Increasing chamber size (height, area, volume) improves the flux estimation.
► The use of non-linear flux calculation significantly reduces flux underestimation.
Journal: Agricultural and Forest Meteorology - Volumes 171–172, 15 April 2013, Pages 124–136