Effect of the template and functional monomer on the textural properties of molecularly imprinted polymers

Molecularly imprinted polymers (MIPs) for zearalenone analysis have been synthesized using the template mimics cyclododecyl 2,4-dihydroxybenzoate (CDHB), resorcinol and resorcylic acid. The MIPs are photochemically prepared from 2-(diethylamino)ethyl methacrylate (2-DAEM), 4-vinylpyridine (VIPY), 2-hydroxyethyl methacrylate (HEMA) or 1-allylpiperazine (1-ALPP) as the functional monomers, trimethylolpropane trimethacrylate (TRIM) as cross-linker, azobis(isobutyronitrile) as initiator and acetonitrile as porogen. Non-imprinted polymers have been also synthesized for reference purposes. The textural properties of the novel polymers (BET areas, pore volumes and pore size distributions) have been determined from nitrogen adsorption–desorption isotherms. These parameters have shown to be strongly dependent on the presence of the template and the monomer nature. Scanning electron microscopy and solvent uptake experiments support these findings. Microporosity contributes less than 7% to the total pore volume for all the polymers prepared. Interestingly, a 3.5 nm pore opening is observed for all the polymers and additional pore apertures in the 20–40 nm region for VIPY-, HEMA- and 2-DAEM-based MIPs whereas a much wider opening size distribution has been measured for the 1-ALPP-based MIP. Molecular modeling and, particularly, 1H NMR experiments demonstrate the strong (2:1) complex formed between 1-ALPP and the diphenolic CDHB (K11 = 4.7 × 104 M−1 and K12 = 2.6 × 102 M−1 in acetonitrile) that make the corresponding MIP the most suitable for zearalenone recognition in real samples.