New rapid methods for determination of total LAS in sewage sludge by high performance liquid chromatography (HPLC) and capillary electrophoresis (CE)

Linear alkylbenzene sulfonates (LAS) are the most common synthetic anionic surfactant used in domestic and industrial detergents, with a global production of 2.4 × 106 t year−1. After use and disposal, LAS may enter the environment by one of the several routes, including by direct discharge to surface water or discharge to water from sewage treatment plants. Sewage treatment plants break down LAS only partly: some of them remain in effluent and other fraction is adsorbed in sewage solid.New and rapid methods for determination of total LAS from sewage sludge based on microwave assisted extraction and HPLC–FL and CE–DAD determination are proposed. The extraction of total LAS is carried out by using microwaves energy, an extraction time of 10 min and 5 mL of methanol. For HPLC–FL determination, mobile phase acetonitrile–water was used, comprising 60% (v/v) from 0 to 1 min and a flow rate of 1 mL min−1 programmed to 100% acetonitrile between 1 and 2 min and a flow rate of 2 mL min−1. The final composition was maintained for a further 5 min. The determination of total LAS by CE–DAD was performed in a phosphate buffer (10 mM, pH 9). The separation voltage was 25 kV and the temperature of the capillary was 30 °C. Injections were performed in the pressure mode and the injection time was set at 12 s. The determination of total LAS is carried out in less than 5 min. The methods did not require clean-up or preconcentration steps. Detection limit for total LAS in the sludge was 3.03 mg kg−1 using HPLC–FL and 21.0 mg kg−1 using CE–DAD, and recoveries were >85% using both determination methods. Concentrations of total LAS obtained using both methods were compared with the sum of concentrations of homologues LAS C-10, LAS C-11, LAS C-12 and LAS C-13 obtained using microwaves assisted extraction and HPLC–FL and CE–DAD determination.