Cr1−xAlxN coatings deposited by lateral rotating cathode arc for high speed machining applications

In this work, a series of Cr1−xAlxN (0 ≤ x ≤ 0.7) coatings were deposited on high speed steel substrates by a vacuum arc reactive deposition process from two lateral rotating elemental chromium and aluminum cathodes in a flowing pure nitrogen atmosphere. The composition, structural, mechanical, and tribological properties of the as-deposited coatings were systematically characterized by energy dispersive analysis of X-rays, X-ray diffraction, nanoindentation, and ball-on-disc tribometer experiments. All of the as-deposited CrAlN coatings exhibited a higher hardness than CrN, showing a maximum hardness of about 40 GPa (at around X = 0.63) which is twice higher than that of the CrN. The wear performance under ambient conditions of the CrAlN coatings was found much better, with both lower friction coefficient and wear rate, than TiAlN coatings deposited by the same technique. The wear rate of the CrAlN coatings against alumina counterpart was about 2–3 orders in magnitude lower than that of the TiAlN coatings. Selected CrAlN coatings with the highest hardness were also deposited on some WC-based end-mills. An evident better performance of the CrAlN-coated end-mills was observed than the TiAlN-coated ones for cutting a hardened tool steel material under high speed machining conditions.