Testing for sufficient signal resetting during sediment transport using a polymineral multiple-signal luminescence approach

• A novel multiple luminescence signal measurement protocol is tested.
• Six luminescence signals bleach at different rates.
• Bleaching plateaus are used to quantify poor bleaching in sediments.
• Approach provides quick and efficient luminescence profiling of samples.

We present a multiple luminescence signal measurement procedure that simultaneously measures six different luminescence signals from a single polymineral aliquot (i.e. multiple-signal, short MS-SAR approach). The six signals show different bleaching rates in bleaching experiments, ranging from rapid bleaching for the quartz dominated blue stimulated luminescence signal (measured at 125 °C, BSL-125), to the slow-bleaching polymineral thermoluminescence signal. The bleaching rate of the infrared stimulated luminescence (IRSL) measured at room temperature (IR-25) and elevated temperature post-IR IRSL (pIRIR-90, pIRIR-155, pIRIR-225) signals decrease with increasing measurement temperature. Owing to these different bleaching rates, the MS-SAR approach allows inference of the degree of bleaching, and thereby information on the transport history of sediments. We test this approach by applying the MS-SAR to four coastal samples from a well-monitored sand-nourishment site at the Dutch coast. Our results show that the proposed MS-SAR approach can be utilised to construct bleaching plateaus which provide an independent and time-effective measure of the degree of poor bleaching in a sediment sample based on the measurement of only a few large aliquots. We propose that the MS-SAR protocol can be used to profile the age, luminescence properties and degree of bleaching of minimal prepared polymineral. This pre-profiling will allow the selection of suitable samples for full luminescence dating analysis in a target-orientated and time-effective manner.