Testing the potential of elevated temperature post-IR IRSL signals for dating Romanian loess

In this study we test the potential of the elevated temperature infrared stimulated luminescence (IRSL) signals for dating Romanian loess. The recently developed post-IR IRSL protocol is applied to Romanian loess using polymineral fine grains extracted from the loess-palaeosol sequence at Mircea Vodă (SE Romania). This approach is aimed at obtaining an additional age control to examine the age discrepancy obtained from previous optically stimulated luminescence (OSL) studies using different grain-sizes of quartz (4–11 μm and 63–90 μm).Two preheat post-IR IR stimulation temperature combinations were used, 250–225 °C and 325–300 °C, respectively. The signals obtained are documented in terms of dose response curve, laboratory tests and fading. Although both post-IR IRSL signals exhibit small fading rates, dose response characteristics indicate that these rates may be laboratory artefacts. The post-IR IRSL signal stimulated at 300 °C is observed to suffer from dose dependent initial sensitivity changes as both natural and regenerated signals are observed to lie above the saturation level of the dose response curve. Uncorrected age results obtained using both post-IR IRSL signals are in general agreement with previously reported silt-sized quartz OSL ages for samples collected from the uppermost loess unit L1. For older material, the post-IR IRSL signal stimulated at 225 °C is considered to provide reliable age results, in agreement with independent age control available for this sequence.

► Post-IR IRSL investigations of polymineral fine grains, Romanian loess.
► Natural and regenerated post-IR IRSL signals were observed in saturation.
► Initial sensitivity changes at high doses for the post-IR IR stimulation at 300 °C.
► For samples in L1, uncorrected post-IR IRSL ages agree with silt-sized quartz ages.
► For older material, post-IR IR225 ages agree with independent age control.