کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
4743823 | 1641839 | 2012 | 8 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: In-situ stress amplification due to geological factors in tunnels: The case of Pajares tunnels, Spain In-situ stress amplification due to geological factors in tunnels: The case of Pajares tunnels, Spain](/preview/png/4743823.png)
Geological and geomechanical anisotropies can significantly increase the magnitude of in-situ stress in a rock mass excavated for tunnelling purposes. Four tunnels for the new high-speed railway lines in Pajares in the Cantabrian Mountains, N. Spain, were analysed and significant deformations was found to have occurred in forty specific zones of these tunnels during excavation, requiring much more support than envisaged before construction. Local factors influencing in-situ stress have been identified in these zones of the tunnels, related to geological structures of high compressive tectonic stress regimes including thrust faults, folds with steep flank dip, or with geomechanical anisotropies in contact zones between rock formations of different strengths. A methodological procedure was applied to four tunnels to assess the influence of the geological anisotropies on the in-situ stress magnitudes. This procedure is based on the analysis of tunnel deformations and the support pressure needed to stabilise the excavations affected by geological anisotropies.The increase of in-situ stress due to local factors is expressed by the Stress Amplification Factor (SAF) defined by the ratio between the K(σH/σV)local value estimated in a particular rock mass tunnel zone and the mean K(σH/σV)regional value representative of the whole rock mass tunnel. Kregional was estimated from hydrofracture tests and from the TSI index. Klocal was calculated from the back analysis of the support pressure required to stabilise the deformed tunnel zones. SAF values for the forty specific tunnel zones ranged from 1.1 to 2.5. This significant increase in the magnitude of in-situ stress emphasises the influence of geological and geomechanical anisotropies in tunnel stability and support design. The results provide a quantitative approach for assessing structural stresses in rock masses for tunnelling excavations.
► Quantitative approach to assess structural stresses for support design.
► Identifying geological structures that may increase horizontal stress magnitude.
► Methodology for estimating increased in-situ stress due to geological factors.
Journal: Engineering Geology - Volumes 137–138, 1 June 2012, Pages 13–20