Alginate microparticles prepared by spray-coagulation method: Preparation, drug loading and release characterization

A spray-coagulation method was developed for the preparation of large scale of porous alginate microparticles. The effect of three variables on porosity was evaluated: (1) alginate solution concentration (2) the concentration of CaCl2 in the coagulation medium and (3) the ratio of guluronic acid to manuronic acid of the alginate. Methylene blue (MB), a highly water-soluble compound and a practically water-insoluble compound, 4-phenylazoaniline (PAA) were used as the model drugs to study drug loading and release characteristics from alginate microparticles. The release of the model compounds from the microparticles was found to depend upon the release medium. Incomplete in vitro release of both model drugs in deionized (DI) water was observed. The release of MB in simulated gastrointestinal fluid (0.1N HCl) was fast and complete, while the release of PAA was slow in 0.1N HCl and fast in phosphate buffer solution (pH 6.8). Interactions between the model drugs and alginate microparticles were identified from scanning electron microscopy (SEM), differential scanning calorimetry (DSC), Fourier transform infrared spectroscopy (FT-IR) analysis. The results indicated that (1) porous alginate microparticles can be produced by the spray-coagulation method; (2) drugs can be loaded by the adsorption method; (3) and the obtained microparticles may be used for delaying the release of drugs of low water solubility in acidic conditions.