Numerical modeling of SiH4 discharge for Si thin film deposition for thin film transistor and solar cells

Amorphous and microcrystalline silicon thin films are used in solar cells as a multi-junction photovoltaic device. Plasma enhanced chemical vapor deposition is used and high deposition rate of a few nm/s is required while keeping film quality. SiH4 is used as a precursor diluted with H2. Electron impact processes give complex interdependent plasma chemical reactions. Many researchers suggest keeping high H/SiHx ratio is important. Numerical modeling of this process for capacitively coupled plasma and inductively coupled plasma is done to investigate which process parameters are playing key roles in determining it. A full set of 67 volume reactions and reduced set are used. Under most of conditions, CCP shows 100 times higher H/SiH3 ratio over ICP case due to its spatially localized two electron temperature distribution. Multi hollow cathode type CCP is also modeled as a 2 × 2 hole array. For Ar, the discharge is well localized at the neck of the hole at a few Torr of gas pressure. H2 and SiH4 + H2 needed higher gas pressure and power density to get a multi hole localized density profile. H/SiH3 was calculated to be about 1/10.