Modification of optical and electrical properties of ITO using a thin Al capping layer

In this study, the work function, transmittance, and resistivity of indium tin oxide (ITO) thin films were successfully modified by depositing an Al capping layer on top of ITO with subsequent thermal annealing. The 5 nm thick Al layer was deposited by a conventional dc magnetron sputtering method and the layer was converted into an aluminum oxinitride by subjecting the sample to rapid thermal annealing (RTA) under a nitrogen atmosphere. The films exhibited a high transmittance of 86% on average within the visible wavelength region with an average resistivity value of 7.9 × 10− 4 Ω cm. Heat-treating the Al/ITO films via RTA resulted in the decrease of the optical band gap from that of bare ITO. In addition, the films showed red-shift phenomena due to their decreased band gaps when the heat-treatment temperature was increased. The resultant electrical and optical characteristics can be explained by the formation of aluminum oxinitride on the surface of the ITO films. The work function of the heat-treated films increased by up to 0.26 eV from that of a bare ITO film. The increase of the work function predicts the reduction of the hole-injection barrier in organic light-emitting diode (OLED) devices and the eventual use of these films could provide much improved efficiency of devices.