Electro-dewatering of wastewater sludge: An investigation of the relationship between filtrate flow rate and electric current

• Filtrate flow rate depends mainly on electrical current during electro-dewatering.
• Instantaneous energy consumption depends mainly on cake dryness during EDW.
• EDW kinetics are enhanced by decreasing the mass of dry solids.
• The EDW process can be properly characterized by an empirical model.

Compared to conventional dewatering techniques, electrical assisted mechanical dewatering, also called electro-dewatering (EDW) is an alternative and an effective technology for the dewatering of sewage sludge with low energy consumption. The objectives of this study were to evaluate the dewatering performance and to determine the influence of the process parameters (e.g. applied electric current, applied voltage, and the initial amount of dry solids) on the kinetics of EDW-process for activated urban sludge. Also significant efforts have been devoted herein to provide comprehensive information about the EDW mechanisms and to understand the relationship between these operating conditions with regards to develop a qualitative and quantitative understanding model of the electro-dewatering process and then produce a robust design methodology. The results showed a very strong correlation between the applied electric current and the filtrate flow rate and consequently the electro-dewatering kinetics. A higher applied electric current leads to faster EDW kinetics and a higher final dry solids content. In contrast, the results of this work showed a significant enhancement of the dewatering kinetics by decreasing the mass of the dry solids introduced into the cell (commonly known as the sludge loading).

Figure optionsDownload high-quality image (328 K)Download as PowerPoint slide