Estuarine shore platforms in Whanganui Inlet, South Island, New Zealand

Whanganui Inlet is a low mesotidal environment where wave energy at the shoreline is limited due to a small fetch, a narrow entrance and tidal flat accretion to intertidal elevations. Wave energy is therefore only an erosive force at high tide and under storm conditions. Despite this low-energy environment extensive shore platforms occur within the inlet. They are sub-horizontal and range in width from 4.1 to 185.2 m with an average of 44.9 m. All the platforms are formed in sandstone of low resistance (mean N-type Schmidt Hammer rebound value of 17 ± 8) and have their seaward edges buried by intertidal sediment flats. The majority of platforms occur at around MHWN level, corresponding to the elevation of those flats. Where wave energy is highest, opposite the inlet's entrance and at those sites with the largest fetch, platforms develop to 0.5-1.0 m below MSL. A higher platform level is also found at MHWS elevations, however it appears to be relict with active erosion of its seaward edge occurring and therefore is most likely related to a higher mid-Holocene sea level. Apart from the location of the lowest platforms little correspondence is found between platform morphology and wave energy. Platform evolution appears to be intrinsically linked to the intertidal sediment flats which determine the degree of surface saturation of the bedrock and, hence, the number of wetting and drying cycles the platforms may undergo. As the seaward edge is buried platform development is primarily through retreat of the landward cliff. This process can, however, be complicated by the migration of intertidal water channels onto the seaward edge of the platforms or relative sea level fall which may rejuvenate landward retreat of the low-tide cliff.